Hill Hand Pump Micron Filter Replacement

Made by Air Arms, it'll grace your gun as beautifully as the original.

Single-shot adapter . Also, single-shot guns tend to be more accurate than repeaters.

.• Also, the weight has been reduced by channeling out the center of each cap.

firearm, air gun or airsoft rifle.2mm to 2.• This Leapers UTG AccuShot scope is a hunter's dream come true. CR2032 3V lithium battery, flip-open lens caps, hex screw, Weaver/Picatinny see-thru rings, cleaning cloth & manual Other features: True Strength scope Nitrogen-filled Shockproof Fogproof Rainproof EZ-TAP illumination-enhancing (IE) technolory with RGB (red-green-black*) in dual-color mode and 36 colors in multi-color mode Zero-reset/zero-lock target turrets Sidewheel parallax adjustment Integral sunshade Black matte finish *If you don't use the illumination, the reticle will be black.

recommended) into the adapter (see note below) Extremely economical.Air Venturi CO2 bulk-fill adapter Fits Umarex EBOS Screw the adapter into the CO2 port of the EBOS With the adapter securely attached, screw a paintball CO2 bulk-fill tank (12 oz.

.

Micron filter replacement Fits all Hill hand pumps (does not fit MK4/MK5 pump*) Easy to replace Instructions: Unscrew the hexagonal connector on top of the base housing (to remove pump) Remove the filter from its seat in the bottom of the housing Place the replacement filter into the housing Replace the o-ring, if needed Reattach the pump and tighten the hexagonal connector Maintain your Hill hand pump, and it'll always be reliable. *For the MK4 micron filter replacement, see PY-A-5558. Replacing the filter is essential for proper functioning of the pump..

This would be an especially good addition to any hard-recoiling spring-piston rifle.69 high 4.12 overall length 4 hex screws secure the base Includes a hex wrench Use on AirForce rifles and pistols or any other airgun or rimfire that has a 3/8 or 11mm dovetail. AirForce 11mm-to-Weaver Adapter 11mm (or 3/8) dovetail-to-Weaver/Picatinny adapter 3.

.

04 clamping & mounting length .12 overall length 4 hex screws secure the base Includes a hex wrench Use on AirForce rifles and pistols or any other airgun or rimfire that has a 3/8 or 11mm dovetail. The cross slots deliver extra gripping area for the rings, making it almost impossible for the scope mount to shift.